A clear, silky smooth, oil based polyurethane finish that provides durable protection with classic hand-rubbed beauty.

PREPARATION

Before getting started, ensure the following:

Fill nail holes, cracks and other defects with a Water Based Putty after applying the first coat of this product for accurate colour matching.
With mineral turpentine, remove stains, dirt, wax, grease and oil.
Using a suitable polish remover, remove any polish.
Bare Timber
If you are applying Wipe-on Poly to Bare Timber:

Sand to a smooth surface.
Remember to remove all sanding dust before coating.
– For naturally oily timbers, seal the timber with Feast Watson Proofseal as per the directions prior to application.
Previously Coated Timber
If you are applying Wipe-on Poly to Previously Coated Timber:

Sand back previously varnished surfaces to a dull finish.
Remove all sanding dust before coating.
Thoroughly clean the surface with Floorclean and allow to dry.
Apply one coat to a small test area. Allow to dry for 6 hours.
Press sticky tape firmly to the surface and pull off quickly.
– If the coating comes off, sand back to bare timber.
– If coating adheres well, sand the entire area with 180 – 240 grit paper for good adhesion, remove dust, then follow application instructions.

APPLICATION

Make sure to shake Mastertouch Wipe-on Poly container for one minute prior to use.

How to apply Wipe-on Poly to Interior Timber:

Apply a generous amount with a clean lint free cloth in the direction of the grain.
Allow to dry for a minimum of 6 hours.

– If you require additional coats, follow the above instructions.

Remember that a light sand with 240 grit sand paper is recommended between coats.
Looking to Stain?

Apply Feast Watson Prooftint following label directions prior to the application of Wipe-on Poly.

Allow Prooftint to dry the recommended period before applying Wipe-on Poly.

• No drip marks
• No brush marks
• Easily applied with cloth